Back to Main IN-WOOD Stain page

PACKAGING & MIXING
IN-WOOD is packaged in 1-gallon and 5-gallon containers. Stir material thoroughly from the bottom of the can before and frequently during application.

SURFACE PREPARATION
Surface must be clean and free of dirt, grease and other foreign matter. Certain types of wood have more surface imperfections than others and care should be taken to make sure that any undesirable surface imperfections are corrected prior to application. New wood with a mill-glaze should either be allowed to weather or should be treated with a mill-glaze remover prior to the application of IN-WOOD. Strippers are not recommenced as they can damage the wood causing inconsistent patterns and color variations. This will maximize penetration and protection.

APPLICATION
IN-WOOD may be applied by brush, roller, spray or dipping. The wood surfaces must be free of dust, grease and other foreign materials. Application rates will vary with surface texture, porosity and method of application. Coverage will average 150 to 300 sq. ft. per gallon.

• For best results and maximum durability, generously apply IN-WOOD to the surface to the point of saturation, then brush or roll the excess material into the wood surface.
• On most new or tight-grained surfaces, one coat is all that is recommended.
• Weathered or porous surfaces may required 2 coats to adequately seal the substrate.

If a second coat is required it must be applied the same time, before the first coat has a chance to dry.

• For best results apply the second coat immediately following the first, one board at a time.
• Back brush or roll excess stain between coats to eliminate surface build up.
• If the temperature is above 75° the first coat of IN-WOOD Stain may dry very quickly. If this occurs, DO NOT apply a second coat as it may not fully penetrate the woods surface resulting in undesired surface build up.
• Do not allow excessive amounts of IN-WOOD Stain to build up on the wood surface.

IN-WOOD cannot be applied to previously painted surfaces unless all of the previous paint has been removed to expose the bare wood. In some cases this can be accomplished through the use of a high power pressure washer.

Thinning of IN-WOOD is not necessary. Tools and equipment are easily cleaned with pure mineral spirits.